EPDM and fibreglass flat roofs in Mildenhall
We are based at Costessey near Norwich and reach Mildenhall via the A11, about 12 miles from Bury St Edmunds. That matters for flat roofing & epdm: it decides how quickly we can inspect, how we get materials on site, and how we sequence work on post-war housing and bungalows.
- County
- Suffolk
- Postcode
- IP28
- Access
- A11
- From Bury St Edmunds
- ~12 miles


How we approach flat roofing & epdm here
EPDM rubber, GRP fibreglass and felt flat roofs for extensions, garages, dormers and outbuildings, with proper falls, trims and outlets.
- EPDM rubber roofs
- GRP fibreglass roofs
- Torch-on felt systems
- Extensions, garages and dormers
What happens after you call
Deck inspection
We lift a section to see the deck; nothing is laid over boards that are soft or damp.
Falls and detailing set out
Firrings, outlet positions and upstand heights are agreed before the membrane arrives.
Membrane installation
EPDM, GRP or felt installed with trims and upstands dressed properly at every edge.
Water test and handover
Outlets checked under flow, edges walked, and the finished roof handed over with the system details.
Our Suffolk service radius
Working out from Mildenhall we regularly cover Brandon, Newmarket, Bury St Edmunds and Ely — a practical radius rather than a marketing map. Flat Roofing & EPDM enquiries here are handled the same way. Work here falls under West Suffolk Council and the IP28 postcode area.
Frequently working in and around Mildenhall industrial estate, airbase-related housing.
Covering Mildenhall and Bury St Edmunds
About 12 miles apart — both are normal working areas for us. Free inspection either way.
Specification options
- Falls and firrings
- Firring pieces set the fall so water leaves the roof rather than sitting on it.
- GRP fibreglass
- Laid in situ over a ply deck for balconies and anything walked on, finished with a hard topcoat.
- EPDM rubber membrane
- One-piece rubber for extensions, dormers and garages — no field seams, and it copes well with movement.
- Trims, upstands and outlets
- Edge trims, correctly formed upstands and adequate outlets — where nearly all flat roof failures actually begin.
Flat Roofing & EPDM FAQs
- Is the roof walkable?
- GRP takes foot traffic and suits balconies and terraces. EPDM is fine for maintenance access but isn't intended as a walking surface — if you need a usable deck, say so and we'll specify accordingly.
- Can you overlay the existing felt?
- Only if the deck below is dry and sound, and we'll lift a section to check. Overlaying a soft deck buys a year or two and costs the whole job again.
- Why does water sit on our flat roof after rain?
- Insufficient fall, a sagging deck or a blocked outlet. On Mildenhall extensions it's usually falls that were never set properly. We reset falls with firrings rather than lay new membrane over the same puddle.
- Does the exposure here change what you'd specify?
- Yes. Open fen exposure means wind uplift is the main enemy, so clipping patterns, verge fixing and adequate falls on flat roofs get more attention than they might in a sheltered street.
- EPDM, fibreglass or felt — which should we choose?
- It depends on the deck, the traffic it takes and the budget. EPDM suits most extensions and garages, GRP suits balconies and anything walked on, and felt still makes sense on larger or awkward outbuildings. We'll set out the options at inspection.
Why customers in Mildenhall call us
Free inspections
Inspections in Mildenhall are free and carry no obligation — including the written quotation.
Fully insured
We carry insurance for the work we take on, and can confirm cover before we start.
Detailing shown before install
Upstands, trims and outlet positions agreed with you before anything is bonded down.
Getting a quote
We will lift a section of the existing roof before pricing. Laying new EPDM or fibreglass over a wet deck is the cheap answer that costs twice. Neighbours in Brandon and Newmarket get the same service, and the written quote is yours to keep and compare.
Covering Mildenhall and Bury St Edmunds
About 12 miles apart — both are normal working areas for us. Free inspection either way.
